Page 358 - Anthropometry, Apparel Sizing and Design
P. 358

Sizing and fit for pressure garments                              351

           different constructions of underwear (with few seams or seamless). From different
           body characteristics, movements (squatting), or materials properties, the underwear
           will cause uncomfortable/comfortable feelings appearing on the buttocks.
              Sixth new measurement NT G was called for by various positions of underwear
           length and bottom. Fig. 13.9 displays six kinds of men’s underwear with different bot-
           tom lines due to heights and angles. There are some important points located on HL
           and CrL:“a”on HL,“b” on underwear bottom, “c”on CrL.
              The first case in Fig. 13.9A with the underwear bottom located upper CrL includes
           different locations of point “b” (briefs and trunks), different bottom girth and slope,
           and also a different length of the side seam. The second case in Fig. 13.9B with an
           underwear bottom located below CrL represents the various underwear styles of
           tight-fitting boxers (from short to long). Fig. 13.10A shows the possible positions
           of bottom lines for the first and second cases, Fig. 13.10B is the relationship between
           the angle and the average values of NT G , Fig. 13.10C is the side length measured from
           natural waist level down to CrL, and Fig. 13.10D is the relation between horizontal
           cross-section girth NT G and h T .
              The one-variable linear equations for calculating new tight oblique girth and hor-
           izontal girth NT G are

               NT G ¼ 81:64 0:89 SL,                                      (13.6)

               NT G ¼ 0:54 h T +54:59,                                    (13.7)
           where NT G is new thigh girth measured below or above natural thigh level, cm; SL is
           side seam length measured from the natural waist, cm; h T is range of NT G below CrL.
              New classifications of lower male torso include new body measurements.
           Table 13.6 shows the types of male bodies on two levels.
              First level is based on W G and H G and defined the total sizes of lower torso visually
           (small or large for slim or obese bodies). The first level has two stages. To identify the
           first stage, the measurements H G and W G are needed. Based on H G , the body can be put
           to A, B, C types in accordance with the intervals established: smaller than 89cm,

                                                      Fig. 13.9 Two cases of underwear
                                                      bottoms: (A) higher than CrL;
                                                      (B) lower than CrL.
   353   354   355   356   357   358   359   360   361   362   363