Page 321 - Making things move_ DIY mechanisms for inventors, hobbyists, and artists
P. 321
298 Making Things Move
FIGURE 10-13 The part stackup inside the base
7. Rest a thrust washer, thrust bearing, and then the other thrust washer on top
of the flange. The inside of the base will start to look like Figure 10-13.
8. Slide the aluminum rod in from the top. Before it hits the sleeve bearing on
the bottom, it should slide through the other sleeve bearing, a 1/2 in shaft
collar, a laser-cut gear, two more 1/2 in shaft collars, and finally the thrust
washer, bearing, washer stack.