Page 464 - Handbook of Electrical Engineering

UNINTERRUPTIBLE POWER SUPPLIES 453

Battery chargers have an energy conversion efficiency of about 85% and a typical power factor
of 0.75 to 0.85 lagging.

17.2.1.1 Charging rates

The basic method of charging batteries depends upon the type of cell i.e. lead-acid (Pb) or nickel-
cadmium (NiCd). The basic method for Pb cells is ‘constant voltage’ where the current varies as the
state of charge changes. Conversely the method for NiCd cells is ‘constant current’ where the cell
voltage varies as the state of charge changes.
When charging Pb cells from a constant voltage source the charging current starts high and
slowly decreases to a constant value when the cells become fully charged. The constancy of the
current is an approximate indication that the cells are fully charged.
However, this is not the case with NiCd cells since constant current charging is preferred. The
best indication with NiCd cells is the specific gravity of the electrolyte. The specific gravity should
ideally be checked before and after charging, but this is not practical on a routine basis.

If batteries are kept in good condition then it is possible to predetermine a charging pattern
to suit the particular battery. This is the basis upon which battery charger manufacturers are able
to design their equipment. Manufacturers will provide charging and discharging diagrams for their
batteries and chargers, see Figure 17.2, which shows the typical requirements for Pb cells.
It is possible to overcharge batteries and this is wasteful on electricity, causes gassing and can
cause internal damage if the current is too high.

Figure 17.2 Charging and discharging of a lead-acid battery.