Page 119 - Build a Remote Controlled Robot

86
TABLE 6-1. Parts List
AMOUNT CHAPTER SIX ITEM

2 Roll of aluminum flashing
# Rolls of double-sided tape, 1/2 inch wide
2 Roll of aluminum tape, 6 inches wide
1 2- 4-foot sheet of hardboard
2 2-inch section of aluminum angle
5 1-inch section of aluminum angle
# 1/8-inch sheet-metal screws
2 Auto courtesy lights
2 SPST switch
1 12-volt horn
1 Rubber gasket (big enough to fit around the vacuum system’s
motor)
1 4-foot length of rubber floor matting
12 1/8-inch-diameter washer
1 Light-up bow tie
1 9-volt battery
1 Can black spray paint
1 Can white spray paint
1 TV snack tray
1 Roll black foam insulation tape
1 1- 2-foot sheet of felt

tuck the skin around obstructions along the framework; just
be sure it looks good from the outside. The panels are held
in place by strips of double-sided tape running the length of
the inside of the framework. Also, sheet metal screws along
the outside of the framework secure the panels in place. The
screws are placed at all the 1/8-inch-diameter predrilled
holes on the sides of the framework. Figure 6-1 illustrates
where and how the panels are attached. You will need to cut
a hole in the center of the lower rear panel to accommodate
the vacuum cleaner motor that protrudes there, and a square
on the lower front panel to accommodate the vacuum outlet.