Page 121 - Build a Remote Controlled Robot

88
CHAPTER SIX

FIGURE 6-2. Mounting tab for rear access panel.

FIGURE 6-3. Tab in place on framework.

robot’s framework so the five tabs sit on top of the panel. Mark
the panel where the holes on the tabs rest, then remove it and
drill 1/8-inch-diameter holes where marked. Now when you
place the panel on top of the tabs, the holes should line up and
the panel can be screwed in place. To complete the panel,
cover it with aluminum tape. Two 6-inch wide strips running
the length of the panel will be enough to cover its front surface
and edges. Figure 6-4 shows the completed panel installed.