Page 162 - Mastering SolidWorks
P. 162
|
Creating a Simple drawing 131
Figure 4.20
Closed loop with
angled side
NOTE the parallel relation will not be applied automatically, as shown in Figure 4.21. the line will be
parallel to the slanted edge, but a relation might need to be applied manually after the line is created.
time relations are applied automatically based on inference lines only when the mouse hovers over
a sketch entity, not an edge. in this particular case, the relation will be replaced by the dimension
between two parallel lines from step 5, so no redundant parallel relation is needed.
Figure 4.21
Using automatic
relationships
