Page 138 - CNC Robotics
P. 138
---- - - - ------ -- --
Chapter 5 / Software Setup and Driver Test
Sync wi r e s Figure 5.22
Connector at interface
end of driver cables.
Use two computer power supplies, one to power the boards and
motors on the y- and z-axes, plus another to power the boa rd and
motor of the x-axis and the case fan. Because the hard drive and
floppy bay were removed, the two power supplies fit nicely in the
case, as you can see in Figu re 5.23.
Figure 5.23
Power supplies inside
box.
Cut a hole in the panel the power supplies, as in Figure 5.24, to
allow the power cords to be plugged in. Turn the switches on and
tuck the wires you won't use aro und the power supplies.
129
