Page 281 - Introduction to Colloid and Surface Chemistry
P. 281

270  Emulsions and foams
          With  y Ow  close  to  zero,  microemulsions  will  form  spontaneously
        and  are  thermodynamically  stable.  The  droplets  of  microemulsions
        tend  to be monodispersed. A microemulsion may form  as a  separate
        phase in equilibrium with excess  oil (O/W) or water (W/O)  (i.e.  it is
        saturated  with  respect  to  droplets).  Microemulsions  are  usually  of
        low  viscosity.
          Microemulsions  represent  an intermediate  state  between  micelles
        and  ordinary  emulsions,  and  it  is  a debatable  issue  whether  or  not
        they  should  be  considered  as swollen micelles rather  than  as small-
        droplet  emulsions.  Droplet  size,  though small, is nonetheless  large
        enough to justify  classification as emulsions. On the other hand, the
        observed thermodynamic  stability and reproducibility  is uncharacter-
        istic of ordinary  emulsions.
          Microemulsions  are  potentially exploitable in any situation where
        the mixing of oil and water is desired. The possibility of using them to
        enhance  tertiary  oil  recovery  has  recently  attracted  a  great  deal of
        attention.
          The recovery of oil from natural reservoirs involves three stages.  In
        the primary stage,  oil is forced out  of the  reservoir  by the pressure  of
        natural  gases.  When  this  pressure  is  no  longer  adequate,  the
        secondary  stage  is  effected  in  which  water  is  pumped  into  the
        reservoir  to  force  out  further  oil.  This  still  usually  leaves  well  over
        half  of the  total oil unrecovered, most of it being trapped  in the pore
        structure  of  the  reservoir  by  capillary  and  viscous  forces.  In  the
        tertiary  stage,  some  of this residual oil can be recovered  by injection
        of oil-miscible fluids and/or forced out  by steam under high pressure.
        The  injection  of  appropriate  microemulsifying  surfactant  mixtures
        offers  the  possibility  of  significantly  enhancing this final stage  of  oil
        recovery.




        Foams  129-130

        A  foam  is  a  coarse  dispersion  of  gas  in  liquid,  and  two  extreme
        structural  situations  can  be  recognised.  The first type (dilute foams)
        consist  of nearly spherical  bubbles separated  by rather thick films of
        somewhat  viscous  liquid.  The  other  type  (concentrated  foams)  are
        mostly gas phase, and consist  of polyhedral gas cells separated  by thin
        liquid films (which may develop from  more dilute foams as a result of
   276   277   278   279   280   281   282   283   284   285   286