Page 184 - Engineered Interfaces in Fiber Reinforced Composites
P. 184
166 Engineered interfaces in jber reinforced composites
Hsueh C.H. and Becher, P.F. (1993). Some consideration of two-way debonding during fiber pull-out. J.
Mater. Sei. Lett. 12, 1933-1936.
Hull,D. (1981). An Introduction to Composite Materials, Cambridge University Press, Cambridge, pp. 81-
101.
Hutchinson, J.W. and Jensen, H.M. (1990). Models for fiber debonding and pullout in brittle composites
with friction. Mech. Mater. 9, 139-163.
Jero, P.D. and Keran, R.J. (1990). The contribution of interfacial roughness to sliding friction of ceramic
fibers in a glass matrix. Scriptu Metall. Mater. 24, 2315-2318.
Jero, P.D., Keran, R.J. and Parthasarathy, T.A. (1991). Effect of interfacial roughness on the frictional
stress measured using pushout tests. J. Am. Ceram. SOC. 74, 2793-2801.
Jiang, K.R. and Penn, L.S. (1992). Improved analysis and experimental evaluation of the single filament
pull-out test. Composites Sci. Technol. 45, 89-103.
Kallas, M.N., Koss, D.A., Hahn, H.T. and Hellmann, J.R. (1992). Interfacial stress state present in a thin
slice fiber pull-out test. J. Mater. Sci. 27, 3821-3826.
Karbhari, V.M. and Wilkins, D.J. (1990). A theoretical model for fiber debonding incorporating both
interfacial shear and frictional stresses. Scripta Metall. Mater. 24 , 1197-1202.
Kelly, A. (1966). Strong Solidr. Clarendon Press, Oxford, Chapter 5.
Kelly, A. and Tyson, W.R. (1965). Tensile properties of fiber-reinforced metals: copper-tungsten and
copper-molybdenum. J. Mech. Phys. Solids. 13. 329-350.
Keran, R.J. and Parthasarathy, T.A. (1991). Theoretical analysis of the fiber pullout and pushout tests. J.
Am. Ceram. Soc. 74, 1585-1596.
Kim, J.K. (1997). Stress transfer in the fiber fragmentation test, part 111. effects of interface debonding
and matrix yielding. J. Mater. Sci. 32, 701-71 1.
Kim, J.K., Baillie, C. and Mai, Y.W. (1991). Instability of interfacial debonding during fiber pull-out.
Scripta Metall. Mater. 25, 3 15-320.
Kim, J.K. and Mai, Y.W. (1991a). High strength, high fracture toughness fiber composites with interface
control-a review. Composites. Sic. Techno!. 41, 333-378.
Kim, J.K. and Mai, Y.W. (1991b). The effect of interfacial coating and temperature on the fracture
behaviors of unidirectional KFRP and CFRP. J. Muter. Sci. 26, 47014720.
Kim, J.K., Baillie, C. and Mai, Y.W. (1992). Interfacial debonding and fiber pull-out stresses, part I. a
critical comparison of existing theories with experiments. J. Mater. Sci. 27, 3143-3154.
Kim, J.K. and Mai, Y.W. (1993). Interfaces in composites in Structure and Properties of Fiber Composites,
Materials Science and Technology, Series Vol. 13, (T.W. Chou, ed.). VCH Publishers, Weinheim,
Germany, Ch. 6, pp. 229-289.
Kim, J.K., Zhou, L.M. and Mai, Y.W. (1993a). Interfacial debonding and pull-out stresses: part 111.
Interfacial properties of cement matrix composites. J. Mater. Sci. 28, 3923-3930.
Kim, J.K., Zhou, L.M. and Mai, Y.W. (1993b). Stress transfer in the fiber fragmentation test. part I. An
improved analysis based on a shear strength criterion. J. Mater. Sci. 28, 6233-6245.
Kim, J.K., Lu, S.V. and Mai, Y.W. (1994a). Interfacial debonding and fiber pull-out stresses: part IV.
Influence of interface layer on the stress transfer. J. Mater. Sei. 29, 554-561.
Kim, J.K., Zhou, L.M. Bryan, S.J. and Mai, Y.W. (1994b). Effect of fiber volume fraction on interfacial
debonding and fiber pull-out. Composites 25, 47W75.
Kim, J.K., Zhou, L.M. and Mai, Y.W. (1994~). Techniques for studying composite interfaces. In
Handbook of Advanced Materials Testing (N.P. Cheremisinoff, ed.), Marcel Dekker, New York, Ch.
22, pp. 327-366.
Lacroix, Th., Tilmans, B., Keunings, R., Desaeger, M. and Verpoest, I. (1992). Modelling of critical fiber
length and interfacial debonding in the fragmentation testing of polymer composites. Composites Sei.
Technol. 43, 379-387.
Lau, M.G., Mai, Y.W. (1990). The fiber pushout problem in ceramic composites. In Proc. Symp.
Composites-Proc., Microstructures and Prop, (M.D. Sacks, ed.), Orlando, pp. 583-591.
Lau, M.G. and Mai, Y.W. (1991). A comparison of fiber pullout and pushout in ceramic fiber composites.
Key Eng. Mater. 53-55, 144-1 52.