Page 181 - Handbook of Electrical Engineering

164 HANDBOOK OF ELECTRICAL ENGINEERING

models are provided with a comprehensive solid-state module for creating the protection functions
such as, long time delay, short time delay, instantaneous tripping, earth fault detection and alarm
messages. The solid-state module may be self-powered or will require an external voltage source
from a UPS.

7.7.3 Cut-off Current versus Prospective Current

Fuses and moulded case circuit breakers that have cut-off characteristics have similar shaped curves
for cut-off current plotted against the prospective current. For a fuse the cut-off current is the value
of current at the end of the melting process of the fuse element, and at the beginning of the arc that
is then created. For a moulded case circuit breaker it is the current that exists when enough energy
has developed to force apart the power contacts, and again the value at the beginning of the arc. The
cut-off current is the highest value of instantaneous current that passes through the fuse or circuit
breaker. It is also called the ‘peak let-through’ current. This current is shown on the y-axis of the
graph. The x-axis is the root-mean-square value of the fault current that is available in the actual
circuit, and is usually taken to be the symmetrical value before any ‘doubling’ factor is included.
The graphs are plotted in two parts. The first part is a straight line that occupies all of the
graphical area available, and is the line for the peak value of the asymmetrical current available
against the symmetrical fault current available. The relationship between these variables is simply
the appropriate ‘doubling’ factor, which can be found from the manufacturer’s curves to be typically
in the range of 2.1 and 2.4 per unit. The second part is a set of curves or lines of lower slope that
apply to all the fuses or circuit breakers in the manufacturer’s range of products. Each one of these
lines intersects the single prospective line, at a point which represents the current that corresponds
to melting a fuse or parting the contacts of a circuit breaker when the instantaneous current is at its
peak value in the first half-cycle. This point is called the ‘threshold current’ in some of the literature,
see Reference 8. At this point no cut-off occurs. Thereafter for higher symmetrical fault currents the
particular rated device will experience an amount of cut-off, the higher the fault current the more
the cut-off will occur. Theoretically the set of lines for the devices will be curved when plotted on
a log-log scale, but in practice manufacturers may approximate these by straight lines. Figure 7.6
shows the characteristic for one fuse and one moulded case circuit breaker, each rated at 40 A for
protecting an induction motor. The location of the device lines or curves in the vertical plane will
vary considerably with different manufacturers and functions, such as motor feeders, heavy duty or
light duty. In general they will be parallel lines or curves for a particular type of device, i.e. one type
with many different ratings in the range of product.

7.7.4 I -squared-t Characteristic

When fuses or moulded case circuit breakers are applied to a circuit it is necessary to ensure that
their I-squared-t characteristics coordinate properly with the thermal capabilities of the downstream
equipment, especially the cables. In order to determine the I-squared-t characteristics of a protective
device it is assumed that the current in the device suddenly changes from a normal load value to the
fault value in a very short period of time, i.e. similar to a step change in a control system. Hence
for each value of current along the x-axis of the device’s time-current characteristic the value of
the current squared multiplied by the corresponding time can be plotted. For cables and busbars the
I-squared-t function equals a constant (k) for each cross-sectional area of conductor, as explained