Page 410 - Injection Molding Advanced Troubleshooting Guide
P. 410
41.3 Sink Troubleshooting 409
hold volume setting on the machine was set too low and the machine transferred as
shown.
®
Figure 41.6 eDART process monitoring showing a machine running with poor velocity to
pressure response
Figure 41.7 shows poor velocity to pressure response on a machine controller. As
is evident in Figure 41.6 the machine pressure drops well under the set point and
then jumps above set pressure before finally stabilizing to the set pressure.
Figure 41.7 Velocity to pressure response on machine controller
