Page 92 - Make Your Own PCBs with EAGLE from Schematic Designs to Finished Boards

FIGURE 4-9 Adding nets.

When adding nets, you can click at any point to add a waypoint (bend in the line), although for this
exercise the resistors are lined up so that you don’t need any corners. When you get to the end point
for a net such as the left-hand lead of R2, the net should stop drawing. It is a sure thing that you
missed the connection point on the component if the net unexpectedly carries on drawing after you
think you have connected it.

If you click the Show command and then select the net between R1 and R2, it will probably tell
you that the net is called N$1, and the other net will be called N$2.

Now draw another net between the two nets, starting from the middle of the net between R1 and
R2. When the net reaches the net between R3 and R4, a little window will pop up (Figure 4-10).