Page 715 - 02. Subyek Computer Aided Design - Beginner’s Guide to SOLIDWORKS 2019- Level 1 by Alejandro Reyes

Beginner's Guide to SOLIDWORKS 2019- Level I

34.21. - After updating the analysis with the modified geometry and material,

review the new results. Now we have a maximum von Mises stress of about 51 ,000

psi, giving us a minimum factor of safety of 2 and a maximum displacement of just

over 0.01 ". Depending on the intent of our design and industry accepted practices,

this may or may not be sufficient to consider our design safe.

1 Fixtures -.1'
2 Loads -.1'1
3 Material -.1'1

4 Run V'l
5 Results
"' -.1'1

Results

~ Show von Mises stress

~ Show displacement

~ Show where factor of
.... safety (FOS) is below.

Based on the specified parameters, the lowest
factor of safety(FOS) found in your design is
2.02895

Use these controls to view the animation.

ij Play animation

l:j Stop animation

~ Done viewing results

~ Back ~ Start Over

1 Fixtures -.1'
2 Loads V'l

3 Material -.1'1
4 Run V'l
5 Results
"' -.1'1

Results

~ Show von Mises stress

~ Show displacement

~ Show where factor of
.... safety (FOS) is below.

Based on the specified parameters, the lowest
factor of safety(FOS) found in your design is
2.02895

Use these controls to view the animation.

ij Play animation

l:j Stop animation

~ Done viewing results

~ Back ~ Start Over

732