Page 403 - Handbook of Electrical Engineering

392 HANDBOOK OF ELECTRICAL ENGINEERING

power electronic controllers are available for even the largest motors, the use of wound rotor motors
has been largely superseded and no longer used in the oil industry.

14.3 GROUP 2 METHODS

In this group there are several systems that use power electronics to provide a variable magnitude
voltage at a variable frequency. Most of the systems use rectifiers and thyristors in the form of
converters and inverters.
Examples are:-

• Thyristor rectifier for variable voltage but constant frequency.
• Thyristor rectifier-inverter for variable voltage and variable frequency.

These systems can be used to supply either induction or synchronous motors, although the first
method is mainly used for small induction motors up to about 20 kW. The second method is suitable
for motors up to about 30,000 kW. In all cases standard motor designs are used but some attention
to the effects of harmonic currents and voltages is necessary on the part of the motor manufacturer.

14.3.1 Variable Voltage Constant Frequency Supply

A thyristor circuit is placed in series with the stator windings of the motor.

In each phase winding circuit there are two thyristors which are connected in parallel but with
opposite polarities. This allows controlled conduction in the windings and allows the current to flow
in both directions through the winding. The phase voltage is varied by delaying the firing of the
thyristors and so only part of the sinusoidal waveform is applied to the motor. The average and rms
values of the applied voltage are therefore reduced.
The torque produced by the motor is therefore reduced in proportion to the square of the rms
value of the applied voltage. Circuits are available for both star and delta connected motors. Closed
loop feedback control may be used to adjust the firing of the thyristors, thereby making accurate
speed regulation possible. These systems are only used for small machines, e.g. up to 20 kW because
they tend to produce many harmonic currents and voltages in the supply.

14.3.2 Variable Frequency Variable Voltage Supply

A typical basic circuit is shown in Figure 14.3 which consists of two main parts, a three-phase
bridge-connected thyristor rectifier and a three-phase bridge-connected thyristor inverter.
The rectifier produces a variable magnitude DC voltage by applying control signals to the
thyristor gates. The output current from the rectifier is specially filtered by a series inductance so
that it is almost a pure DC current which passes through the three branches of the bridge-connected
inverter in such a way that the three currents are caused to flow into the motor. This is achieved by
cyclically firing the gates of the inverter and the frequency of the cyclic firing determines the AC
fundamental frequency at the motor. A variable frequency oscillator is used to generate the firing
pulses for the inverter thyristors. It is possible to arrange for the oscillator to accept feedback signals