Page 222 - MEMS Mechanical Sensors

8.4 Future Inertial Micromachined Sensors 211

[69] Hopkin, I., “Performance and Design of a Silicon Micromachined Gyro,” Proc. Symp.
Gyro Technology, Stuttgart, Germany, 1997, pp. 1.0–1.11.
[70] Fell, C., I. Hopkin, and K. Townsend, “A Second Generation Silicon Ring Gyroscope,”
Symposium Gyro Technology, Stuttgart, Germany, September 1999.
[71] Watanabe, Y., et al., “Five-Axis Motion Sensor with Electrostatic Drive and Capacitive
Detection Fabricated by Silicon Bulk Micromachining,” Sensors and Actuators, Vol.
A97–98, 2002, pp. 109–115.
[72] Shearwood, C., et al., “Levitation of a Micromachined Rotor for Application in a Rotating
Gyroscope,” Electronic Letters, Vol. 31, No 21, 1995, pp. 1845–1846.
[73] Shearwood, C., et al., “Development of a Levitated Micromotor for Application as a Gyro-
scope,” Sensors and Actuators, Vol. A83, 2000, pp. 85–92.
[74] Fukatsu, K., T. Murakoshi, and M. Esashi, “Electrostatically Levitated Micro Motor for
Inertia Measurement System,” Proc. 10th Intl. Conf. Solid-State Sensors and Actuators
(Transducer ’99), Vol. 2, Sendai, Japan, 1999, pp. 1558–1561.
[75] Houlihan, R., and M. Kraft, “Modelling of an Accelerometer Based on a Levitated Proof
Mass,” J. Micromech. Microeng., Vol. 12, No. 4, 2002, pp. 495–503.