Page 242 - Mastering SolidWorks

|
tutorial: SketchinG calculator 213

Figure 6.31
Build a triangle with a
rounded top without
dimensions.

Figure 6.32
Sketching stacking rings

4. Put a diameter dimension on each circle. In the PropertyManager for each dimension,
rename the dimension for ring1dia@Sketch1, ring2dia, and so on. This is shown in
Figure 6.33.
5. Place a dimension from the center of the bottom circle to the construction line, and place
the dimension on the far side of the construction line from the circle. This creates a
diameter dimension.
6. Place a dimension for the middle circle in the same way as the bottom circle, but this time,
make the dimension value about 75 percent of the first diameter.
7. Complete the sketch as shown in Figure 6.34, with all the dimensions and sketch relations.