Page 563 - 02. Subyek Computer Aided Design - Beginner’s Guide to SOLIDWORKS 2019- Level 1 by Alejandro Reyes

Beginner's Guide to SOLIDWORKS 2019- Level I

Double-click the diameter dimension and change its value to 0.575". Click

the "Rebuild" icon as shown, and then OK to complete the "Modify" command.

Rebuilding the model will tell SOLIDWORKS to update any models that were

changed, like the 'Offset Shaft' in this case.

Modify

+ •••

X -u~ ~

D1 @Sketch1
Regenerate the model with the current value.

.575

27.6. -After changing the shaft's diameter run the "Interference Detection"

command again to confirm that we have resolved the interference between the

shaft and the housing. The only interference displayed should be the fasteners. Be

aware that we may see additional gear-on-gear interferences when the shaft's

diameter changed; if this is the case, ignore them. Click OK to finish. In the next

image non-interfering components are not hidden.

~ Interference Det ection ®

~ X

Selected Components A ;..

Gear Box Complete.SLDASM

0

calculate

0 Excluded Components v

Results

E:;j Fasteners

c

2 Ignored Interferences

L lgnore J

0 Component view

568