Page 158 - Machinery Component Maintenance

Machiner! Foundations und Grouting 141

4. IF WEDGES WERE USED TO LEVEL THE BASEPLATE, THEY
SHALL BE REMOVED AT THIS TIME AND THEIR VOIDS IN THE
GROUT FILLED WITH ESCOWELD 7501 PUTTY. SHIMS SHALL
BE LEFT IN PLACE.
5. THE TOP OF THE BASEPLATE SHALL BE SOUNDED FOR VOIDS.
AFTER ALL THE VOIDS HAVE BEEN DEFINED THE BASEPLATE
SHALL HAVE TWO HOLES DRILLED THROUGH TO EACH VOID
IN OPPOSITE CORNERS OF THE VOIDS. ONE OF THE PAIR OF
HOLES SHALL BE TAPPED AND FITTED WITH A PRESSURE GREASE
FITTING. THE OTHER HOLD SHALL BE USED AS A VENT HOLE
FOR ITS VOID. THE VOID SHALL BE FILLED WITH UNFILLED
ESCOWELD 7505 WITH A HAND GREASE GUN. CARE MUST BE
TAKEN TO PREVENT LIFTING THE BASEPLATE SHOULD A BLOCK-
AGE OCCUR BETWEEN THE GREASE FITTING AND THE VENT.
WHEN THE VOID HAS BEEN FILLED THE GREASE FITTING
SHALL BE REMOVED AND BOTH HOLES DRESSED SMOOTH.
6. ALL EDGES OF THE EPOXY GROUT SHALL BE DRESSED SMOOTH
BY GRINDING TO A 114 INCH CHAMFER,
IX. CLEAN-UP
1, IMMEDIATELY AFTER GROUTING IS COMPLETED ALL TOOLS AND
MIXING EQUIPMENT SHALL BE CLEANED USING EITHER WATER
OR ESCOWELD 9615 CLEAN-UP SOLVENT.
2. ALL UNUSED MIXED EPOXY MATERIALS SHALL BE DISPOSED
OF IN ACCORDANCE WITH INSTRUCTIONS ON THE EPOXY
CONTAINERS.